At present, the production equipment of strong disperser grout is an intelligent mixer with high efficiency and no dead spots that has been experimentally confirmed. Compared with high-speed dispersers, the key blade method is to have two butterfly mixing blades on the top and a high-speed dispersing disc blade on the bottom, followed by a mountain shaped scraper blade to scrape the edges and bottom, making the raw materials undergo complex basic movements in the kettle. For high-speed dispersers with only one high-speed dispersing disc blade, the advantages are very significant.

The strong dispersing machine for the production of grout has good sealing performance, can be vacuum packaged, and has excellent practical effects in removing bubbles from exhaust pipes. The kettle cover can be lifted and lowered by hydraulic pressure, and the kettle body can be moved freely, with high efficiency and convenient practical operation. It has been widely used.

What are the common problems in the maintenance and repair of the production equipment for strong dispersing machine grout? The key includes three complete processes: pre boot, boot, and shutdown:

Before starting up:

1. Check if the oil level of the disperser is filled to the required position. When the oil level is low, it should be immediately added to the required level; When the oil level is high, it is advisable to place it in the required location.

2. Check if the tightness of the V-belt is moderate.

3. Forcefully rotate the impeller, it should rotate smoothly without any friction sound.

4. Check whether each standard component is loose and whether there is any leakage at each sealing position.

5. Turn on the main motor of the disperser and check if the mixing direction is the same as the required orientation of the machine equipment.

6. Only after confirming the accuracy of the above inspection work can the machine be turned on.

At startup:

1. Place the impeller in the management center of the dispersing machine dish, lower the button, and lower it to a lower or designated position.

2. Both joysticks must be securely fastened before turning on the device.

3. Turn on the main motor and press the button according to the actual operation speed ratio,

4. During the operation process, attention should be paid to the current condition frequently. If overweight operation is found, the machine should be stopped immediately to check the cause and take measures before running the disperser again.

When shutting down:

1. Stop the main motor first to stop the rotation of all impellers.

2. Turn on the disperser lift button to raise the main shaft bearing impeller into the container and clean the impeller.